Company
Tiger Crusehr PCL Series PCL Vertical Shaft Impact Crusher(Sand Making Machine)
PCLS vertical shaft impact crusher (sand making machine) is my company after years of mining machinery equipment developed on the basis of the introduction of similar products of advanced technology and combining with Germany, the development of high energy low consumption equipment with international advanced level, and the equipment discharging granularity small and uniform (3 mm to 8 mm), and parts durability is strong, less wearing parts, its maintenance is convenient. Compared with the traditional crusher low energy consumption, large production capacity, output per hour can between 30-130 tons, and its performance in all kinds of ores fine broken equipment plays an irreplaceable role, is currently the most effective, practical and reliable equipment. This equipment is widely used in metal and non-metallic ores, cement, refractory, bauxite, silicon carbide, building materials, artificial sand and finely, especially on the hard, hard material is more superiority than other types of crusher.
Quality Certification: ISO9001&CE
Mesh Size of Feed: ≤ 60 mm
Production Capacity: 20-380 T/h
Application Area: All kinds of ores, cement, refractory, aluminum every soil clinker, carborundum, glass raw materials, mechanisms, sand, stone and metallurgical slag, and other industries.
Applicable Materials: Pebble, granite, basalt, quartz, iron ore, diabase, coal gangue etc.
Advantages&Characteristics:
1. Deep cavity type rotor after optimization design, through material quantity increases by about 30%.
2. As high sand ratio, the size and the shape of product is good.
3. With functions of finely, coarse grinding.
4. Week guard can use back up and down after partial wear, improve material utilization, can improve the service life of more than 48%.
5. Little affected by the material moisture content, water cut of up to 8%.
6. Stone hit stone, stone while the iron is hot high efficiency and energy saving, high crushing efficiency. 7. Product into a cube, bulk density is big, small iron contamination.
7. Less wear of impeller from the lining, easy maintenance.
8. Low wearing parts consumption - the best material impact Angle of crushing cavity. Problems in the design, less friction and wear parts, 30% lower than conventional equipment running cost, reduce the use of the equipment cost directly.
